A trial-use, non-industry-specific recommended practice for voltage sag and short interruption ride-through performance and compliance testing for all electrical and electronic equipment connected to low-voltage power systems that can experience malfunction or shutdown as a result of reductions in supply voltage lasting less than one minute is detailed in this document. Testing procedures and requirements for test equipment are clearly defined within this document to reflect this electrical environment, including single-phase, two-phase, and three-phase balanced and unbalanced voltage sags. Requirements for certification and test reporting, including characterization of voltage-sag ride-through equipment are also defined.
- Sponsor Committee
- IAS/ICPS/SDC - Industrial & Commercial Power Systems Standards Development Committee
- Status
- Superseded Standard
- PAR Approval
- 2009-09-11
- Superseded by
- 1668-2017
- Board Approval
- 2014-08-21
- History
-
- Published:
- 2014-09-22
Working Group Details
- Society
- IEEE Industry Applications Society
Learn More About IEEE Industry Applications Society - Sponsor Committee
- IAS/ICPS/SDC - Industrial & Commercial Power Systems Standards Development Committee
- Working Group
-
1668_WG - Voltage Sag Ride-through Working Group
Learn More About 1668_WG - Voltage Sag Ride-through Working Group - IEEE Program Manager
- Patricia Roder
Contact Patricia Roder - Working Group Chair
- Douglas Dorr
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards