The evolution of technology and the advancement of communications have resulted in an increased awareness of energy bursts. Such bursts which interfere with desired signals are properly classified as noise. In the transmission of information, for example, signals which have low redundancy are highly vulnerable to burst interference. In acoustics, audible sound of the impulsive type is an increasingly important problem because of the annoyance it may cause; moreover, high-intensity solid-borne energy of an impulsive character sometimes produces structural failures. While quantities of relatively short time duration are of widespread interest, little is known about the statistics of these quantities insofar as peak amplitudes, repetition rates and wave shapes are concerned. In view of the increasingly important role played by energy bursts in modern technology, accepted procedures for identifying and characterizing burst-like events should be established. Obviously, no single method of measurement will satisfy all requirements equally well. The techniques described here are based on a set of definitions which have been chosen to be easily adaptable to many engineering applications.
- Standard Committee
- SASB/SASB - Standards Association Standards Board
- Status
- Inactive-Withdrawn Standard
- Board Approval
- 1964-05-01
- History
-
- Published:
- 1964-04-30
Working Group Details
- Society
- Standard Committee
- SASB/SASB - Standards Association Standards Board
- Working Group
-
ADMIN - Project Administration
- IEEE Program Manager
- Soo Kim
Contact Soo Kim
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards