High-frequency heating equipments divide into two main types: (1) those used for dielectric heating, and (2) those used for induction heating. The induction heating equipments again divide into seven types: (1) commercial power line; (2) rotary generator; (3) mercuryarc converter; (4) gaseous-tube converter; (5) mercuryhydrogen spark-gap converter; (6) quenched spark-gap converter; (7) vacuum-tube generator. Dielectric heating equipments in general use a vacuum tube oscillator as a source of radio-frequency power ranging in frequency from 2 megacycles to hundreds of megacycles. At frequencies above about 200 megacycles, the power is generated by devices other than a conventional vacuum tube, such as a magnetron, Klystron or other microwave device. A dielectric heating generator is normally a high-voltage generator, and application requires high-voltage radio-frequency matching techniques. An induction heating generator is essentially a high-current device operating into very low impedance circuits and sometimes requires transformation in the load circuit to provide the desired heating effect.
- Standard Committee
- SASB/SASB - Standards Association Standards Board
- Status
- Inactive-Withdrawn Standard
- Board Approval
- 1955-12-01
- History
-
- Published:
- 1954-11-30
Working Group Details
- Society
- Standard Committee
- SASB/SASB - Standards Association Standards Board
- Working Group
-
ADMIN - Project Administration
- IEEE Program Manager
- Soo Kim
Contact Soo Kim
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards