Electrical, mechanical, and safety requirements of ventilated, non-ventilated, and sealed dry-type distribution and power transformers or autotransformers (single and polyphase, with a voltage of 601 V or higher in the…
A general form for the preparation of test procedures is provided in this standard. Points to be considered by technical committees in the preparation of specific instructions for the thermal…
Within the context of the ISO/IEEE 11073 family of standards for device communication, a normative definition of communication between personal telehealth insulin pump devices and compute engines (e.g., cell phones,…
The editing instructions for this corrigendum are to insert a diagram as Figure 52 in the place where it is 19 currently missing from the approved but unpublished document in…
Information on the installation of fire-rated, power, control, and instrumentation cables suitable for hydrocarbon pool fires, as typically used in petroleum, chemical, and similar plants, offshore marine platforms, in emergency…
High-potential test voltages for excitation systems used with synchronous machines are established. Test voltages are established based on whether equipment is connected to the exciter power circuit or is electrically…
Specifications for high voltage (above 1000 volts) Class A and Class B expulsion and current-limiting fuses. This includes: a) Expulsion type Class A [distribution class] fuses, fuse cutouts, fuse disconnecting…
Certain mechanical requirements relating to tank strength as well as static and dynamic tank pressure mitigation for liquid-immersed distribution transformers are covered in this standard. The electrical and mechanical requirements…
This document describes electrical, mechanical and test requirements of liquid-immersed, single- and three-phase, 50 Hz and 60 Hz, self and forced-air cooled, distribution, overhead and substation, step-voltage regulators, 1 000…
