The design, installation, and protection of wire and cable systems in substations are covered in this guide, with the objective of minimizing cable failures and their consequences
- Standard Committee
- PE/SUB - Substations Committee
- Status
- Active Standard
- PAR Approval
- 2011-03-31
- Superseding
- 525-2007
- Board Approval
- 2016-06-30
- History
-
- ANSI Approved:
- 2017-12-06
- Published:
- 2016-11-15
Working Group Details
- Society
- IEEE Power and Energy Society
- Standard Committee
- PE/SUB - Substations Committee
- Working Group
-
WGD2 - WGD2 - Cable Systems in Substations
- IEEE Program Manager
- Patricia Roder
Contact Patricia Roder - Working Group Chair
- Prudhvi Anand Bhattiprolu
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
P525
IEEE Draft Guide for the Design and Installation of Cable Systems in Substations
The design, installation, and protection of wire and cable systems in substations are covered in this guide, with the objective of minimizing cable failures and their consequences.
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
525-1992
IEEE Guide for the Design and Installation of Cable Systems in Substations
Guidance for the design, installation, and protection of wire and cable systems in substations with the objective of minimizing cable failures and their consequences is provided. The design of wire and cable systems in gen
525-2007
IEEE Guide for the Design and Installation of Cable Systems in Substations
The design, installation, and protection of wire and cable systems in substations with the objective of minimizing cable failures and their consequences are covered in this guide.
525-2007/Cor 1-2008
IEEE Guide for the Design and Installation of Cable Systems in Substations - Corrigendum 1
Correcting the axis labels of a figure J1 located in annex J.
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards