
This guide describes VLF withstand and other diagnostic tests and the measurements that are performed in the field on shielded medium and high-voltage cables rated 5 kV and above with extruded and laminated insulation. VLF test methods utilize ac signals at frequencies less than 1 Hz. The most commonly used, commercially available, VLF test frequency is 0.1 Hz. Whenever possible the guide addresses testing of complete cable systems. Tables are included of the recommended test voltage levels for installation, acceptance, and maintenance tests.
- Sponsor Committee
- PE/IC - Insulated Conductors
Learn More - Status
- Active PAR
- PAR Approval
- 2022-09-21
- Superseding
- 400.2-2013
Working Group Details
- Society
- IEEE Power and Energy Society
Learn More - Sponsor Committee
- PE/IC - Insulated Conductors
Learn More - Working Group
-
F03W/P400.2_WG - Working group for the Guide for Field Testing of Shielded Power Cable Systems Using Very Low Frequency (VLF)
Learn More - IEEE Program Manager
- Ron Hotchkiss
Contact - Working Group Chair
- Robert Hampton
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
400.2-2013
IEEE Guide for Field Testing of Shielded Power Cable Systems Using Very Low Frequency (VLF)(less than 1 Hz)
Very low frequency (VLF) withstand and other diagnostic tests and measurements that are performed using VLF energization in the field on shielded power cable systems are described in this guide. Whenever possible, cable systems are treated in a similar manner to individual cables. Tables are included as an aid to identifying the effectiveness of the VLF ac voltage test for various cable system insulation problems.
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards