Superseded by 1115-2000. Methods for defining the dc load and for sizing a nickel-cadmium battery to supply that load are described. Installation, maintenance, qualification, testing procedures, and consideration of battery types other than nickel-cadmium batteries are not included. Design of the dc system and sizing of the battery charger(s) are also not included.
- Standard Committee
- PE/EDPG - Energy Development & Power Generation
- Status
- Superseded Standard
- Superseded by
- 1115-2000
- Board Approval
- 1992-09-17
- History
-
- ANSI Approved:
- 1993-03-09
- Published:
- 1993-02-12
Working Group Details
- Society
- IEEE Power and Energy Society
- Standard Committee
- PE/EDPG - Energy Development & Power Generation
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
1115-2025
IEEE Recommended Practice for Sizing Nickel-Cadmium Batteries for Stationary Applications
The sizing of nickel-cadmium batteries used in standby operation for stationary applications is discussed in this recommended practice.
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
1115-2000
IEEE Recommended Practice for Sizing Nickel-Cadmium Batteries for Stationary Applications
The sizing of nickel-cadmium batteries used in full float operation for stationary applications is covered in this recommended practice.
1115a-2007
IEEE Recommended Practice for Sizing Nickel-Cadmium Batteries for Stationary Applications Amendment 1: Additional Discussion on Sizing Margins
This amendment provides additional guidance on sizing margins that may be applied when nickel-cadmium batteries are used in stationary applications involving an element of charge-discharge cycling.
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
1115-2014
IEEE Recommended Practice for Sizing Nickel-Cadmium Batteries for Stationary Applications
The sizing of nickel-cadmium batteries used in standby operation for stationary applications is discussed in this recommended practice.