The smart utility network (SUN) physical layers (PHYs) in IEEE Std 802.15.4(TM)-2015 are changed by this amendment to enable the use of the 870--876 MHz and 915--921 MHz bands in…
Line traps inserted into a power line to provide a high impedance at power-line-carrier frequencies (30 kHz to 500 kHz) are covered in this standard. The purpose is to isolate…
Link Aggregation allows parallel point-to-point links to be used as if they were a single link and also supports the use of multiple links as a resilient load-sharing interconnect between…
Uniform procedures are established for manual and automatic measurement of audible noise from overhead transmission lines. Their purpose is to allow valid evaluation and comparison of the audible noise performance…
Clause 116 through Clause 124 and Annex 119A through Annex 120E are added by this amendment to IEEE Std 802.3-2015. This amendment includes IEEE 802.3 Media Access Control (MAC) parameters,…
A physical (PHY) layer enabling the use of the 865 MHz to 867 MHz band in India is defined in this amendment. The supported data rate should be at least…
How Uniform Resource Name (URN) values are allocated in IEEE 802(R) standards is described in this amendment to IEEE Std 802(R)-2014. (The PDF of this standard is available at no…
Media Access Control security (MACsec) Key Agreement protocol (MKA) data elements and procedures that provide additional security and manageability capabilities, including the ability to maintain secure communication while the operation…
An introduction to a series of guides on the application of surge protectors and protective circuits used in information and communications technology circuits, including Smart Grid data networks, is provided…
