Revision of IEEE Std 522-1992 Suggestions are made for testing the dielectric strength of the insulation separating the various turns from each other within multiturn form-wound coils to determine their…
Reaffirmed March 2012. A generic specification, including design and testing, for transmission modular restoration structure components used by electric utilities is provided.
This guide provides techniques for designers and facility operators to apply in determining the arc flash hazard distance and the incident energy to which employees could be exposed during their…
Certain electrical, dimensional, and mechanical characteristics are set forth as well as certain safety features of three-phase, 60 Hz., mineral-oil-immersed, self-cooled, pad-mounted, compartmental-type distribution transformers. These transformers are rated 2500…
The design, performance, use, testing, and installation of temporary protective grounding systems, including the connection points, as used in permanent and mobile substations,are covered in this guide.
An approach to prepare a specification for an electronic device connected in series to compensate voltage fluctuations is presented. This guide intends to provide a base specification to allow users…
This recommended practice provides information on the use of high direct voltage for proof tests and for periodic diagnostic tests on the ground wall insulation of stator (armature) windings in…
The scope of this recommended practice is the performance of surge testing on electrical and electronic equipment connected to low-voltage ac power circuits, specifically using there commended test waveform defined…
A test procedure for impulse testing of insulated conductors (cables) and cables with accessories installed (cable systems) is provided in this standard. This procedure can be used as a design…
