DryType-WGC57.12.01 - Dry Type Transformers - General Req. Working Group

Robert Ballard

This standard describes electrical and mechanical requirements of single and polyphase ventilated, nonventilated, and sealed dry-type distribution and power transformers or autotransformers, with a voltage of 601 V or higher in the highest voltage winding. This standard applies to all dry-type transformers, including those with solid cast and/or resin-encapsulated windings except as follows: a) Instrument transformers; b) Step- and induction-voltage regulators; c) Arc-furnace transformers; d) Rectifier transformers; e) Specialty and general-purpose transformers; f) Mine transformers; g) Testing transformers; h) Welding transformers. NOTE--Where IEEE standards do not exist for the transformers mentioned above or for otherre special transformers, this standard may be applicable as a whole or in parts subject to agreement between the parties responsible for the application and for the design of the transformer.

Superseded by IEEE Std C57.12.01-2005 Electrical, mechanical, and safety requirements of ventilated, nonventilated, and sealeddry-type distribution and power transformers or autotransformers, single and polyphase, with a volt-age of 601 V or higher in the highest voltage winding, are described. Information that can be usedas a basis for the establishment of performance, interchangeability, and safety requirements of equipment described, and for assistance in the proper selection of such equipment, is given.

Electrical, mechanical, and safety requirements of ventilated, non-ventilated, and sealed dry-type distribuion and power transformers or auto transformers (single and polyphase, with a voltage of 601 V or higher in the highest voltage winding) are described.