Standard Details
This part of IEC 62271 applies to all overhead, pad mounted, dry vault and submersible single or multi-pole alternating current automatic circuit reclosers and fault interrupters for rated maximum voltages above 1 000 V and up to 38 kV.
Standards Committee | |
Status |
Superseded
|
Superseded by | |
Board Approval |
2012-08-30
|
History |
Published Date:2012-09-18
|
Additional Resources Details
PAR | |
Downloads |
Working Group Details
Working Group |
RODE-WG_C37.60 - RODE - Reclosers and Other Distribution Equipment Subcommittee - C37.60
|
Working Group Chair |
David Stone
|
Standards Committee | |
Society | |
IEEE Program Manager | |
Existing Standards |
This standard applies to all overhead, pad mounted, dry vault and submersible single or multi-pole alternating current automatic circuit reclosers and fault interrupters for rated maximum voltages above 1000 V. In order to simplify this standard where possible, the term recloser has been substituted for automatic circuit recloser or fault interrupter or both.
|
Required definitions, ratings, procedures for performing design tests and production tests, and construction requirements for subsurface, vault, and pad-mounted load-interrupter switchgear and fused load-interrupter switchgear for ac systems up to 38 kV are specified
|
|
This Standard applies to all overhead, pad mounted, dry vault and submersible single or multi-pole alternating current automatic circuit reclosers and fault interrupters for rated maximum voltages above 1000 V and up to 38 kV. The following is also included in section 1: In order to simplify this standard where possible, the term recloser/FI (reclosers/FIs) has been substituted for automatic circuit recloser or fault interrupter or both. NOTE--When reclosers are applied in substation, special considerations may apply.
|
|
Required definitions, ratings, procedures for performing design tests, production tests, and construction requirements for overhead, pad-mounted, dry vault, and submersible automatic circuit reclosers and fault interrupters for alternating systems up to 38 kV are specified.
|
|
IEEE Std C37.60-2003, IEEE Standard for Overhead, Pad-Mounted, Dry Vault, and Submersible Automatic Circuit Reclosers and Fault Interrupters for Alternating Current Systems Up to 38 kV
|
|
This part of IEC 62271 applies to all overhead, pad-mounted, dry vault and submersible single or multi-pole alternating current automatic circuit reclosers for rated maximum voltages above 1 000 V and up to and including 38 kV.
Devices that require a dependent manual operation are not covered by this document.
In order to simplify this document where possible, the term recloser (or reclosers) has been substituted for automatic circuit recloser(s) or cutout mounted recloser(s) or both.
|