This standard applies to enclosed assemblies of single-phase and three-phase, dead-front and live-front, subsurface, vault, and padmounted, load-interrupter switches with or without protective devices such as fuses or fault interrupters, up to 38 kV rated maximum voltage.
- Sponsor Committee
- PE/SWG - Switchgear
Learn More About PE/SWG - Switchgear - Status
- Active PAR
- PAR Approval
- 2021-06-16
- Superseding
- C37.74-2014
Working Group Details
- Society
- IEEE Power and Energy Society
Learn More About IEEE Power and Energy Society - Sponsor Committee
- PE/SWG - Switchgear
Learn More About PE/SWG - Switchgear - Working Group
-
RODE/C37.74 - C37.74 - Standard Requirements for Subsurface, Vault, and Padmounted Load-Interrupter Switchgear and Fused Load-Interrupter Switchgear for Alternating Current Systems up to 38 kV
Learn More About RODE/C37.74 - C37.74 - Standard Requirements for Subsurface, Vault, and Padmounted Load-Interrupter Switchgear and Fused Load-Interrupter Switchgear for Alternating Current Systems up to 38 kV - IEEE Program Manager
- Jennifer Santulli
Contact Jennifer Santulli - Working Group Chair
- KENNEDY DARKO
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
C37.74-2014
IEEE Standard Requirements for Subsurface, Vault, and Padmounted Load-Interrupter Switchgear and Fused Load-Interrupter Switchgear for Alternating Current Systems up to 38 kV
Required definitions, ratings, procedures for performing design tests and production tests, and construction requirements for subsurface, vault, and padmounted load-interrupter switchgear and fused load-interrupter switchgear for ac systems up to 38 kV are covered in this standard.
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards