Rigid-bus structures for outdoor and indoor, air-insulated, and alternating-current substations are covered. Portions of this guide are also applicable to strain-bus structures or direct-current substations, or both. Ampacity, radio influence, vibration, and forces due to gravity, wind, fault current, and thermal expansion are considered. Design criteria for conductor and insulator strength calculations are included.
- Standard Committee
- PE/SUB - Substations Committee
- Status
- Inactive-Withdrawn Standard
- Superseded by
- 605-1998
- Board Approval
- 1984-06-14
- History
-
- Withdrawn:
- 1993-12-02
- ANSI Approved:
- 1985-11-15
- Published:
- 1987-05-20
Working Group Details
- Society
- IEEE Power and Energy Society
- Standard Committee
- PE/SUB - Substations Committee
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards