This standard provides general requirements, direction, and methods for qualifying Class1E electric cables, field splices, factory splices, and factory rework for service in nuclear power generating stations. Categories of cables covered are those used for power, control, and instrumentation services, including signal and communication cables. Field cables, wires, and splices are within the scope of this standard. Cables, wires, and splices within or integral to other devices (e.g., instruments, panels, motors, etc.) should be qualified using the requirements in the applicable device standard or IEEE Std 323-1983, as appropriate. However, this standard's requirements may be applied to the wire and cable within these devices.
- Sponsor Committee
- PE/ESSB - Energy Storage & Stationary Battery Committee
Learn More About PE/ESSB - Energy Storage & Stationary Battery Committee - Status
- Superseded Standard
- PAR Approval
- 2001-02-21
- Superseded by
- 484-2019
- Superseding
- 484-1996
- Board Approval
- 2002-09-12
- History
-
- ANSI Approved:
- 2003-01-22
- Published:
- 2003-02-12
- Reaffirmed:
- 2008-12-10
Working Group Details
- Society
- IEEE Power and Energy Society
Learn More About IEEE Power and Energy Society - Sponsor Committee
- PE/ESSB - Energy Storage & Stationary Battery Committee
Learn More About PE/ESSB - Energy Storage & Stationary Battery Committee - Working Group
-
WG_484 - Vented Lead-Acid Batteries Working Group
- IEEE Program Manager
- Michael Kipness
Contact Michael Kipness - Working Group Chair
- Joseph Stevens
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
484-2019
IEEE Recommended Practice for Installation Design and Installation of Vented Lead-Acid Batteries for Stationary Applications
Recommended design practices and procedures for storage, location, mounting, ventilation, instrumentation, preassembly, assembly, and charging of vented lead-acid batteries are provided. Required safety practices are also included. These recommended practices are applicable to all stationary applications. Specific applications, such as emergency lighting units, semiportable equipment, and alternate energy applications, may have other appropriate practices and are beyond the scope of this recommended practice.
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards