Stationary Meter Test Units (MTUs) permanently installed in laboratories, used for testing and calibration of direct current electrical energy meters, in particular for their type test, acceptance test, and verification test, are applied to in this guide. The requirements for automatic MTUs and applies to newly manufactured MTUs to test electrical energy meters on direct current systems with a voltage up to 1 500 V is covered. Finally, it should be noted that the entire guide does not contain normative requirements
- Standard Committee
- PE/PSIM - Power System Instrumentation and Measurements
- Status
- Active Standard
- PAR Approval
- 2020-09-24
- Board Approval
- 2023-02-15
- History
-
- Published:
- 2023-04-28
Working Group Details
- Society
- IEEE Power and Energy Society
- Standard Committee
- PE/PSIM - Power System Instrumentation and Measurements
- Working Group
-
TEDCEM/P2960 - Testing Equipment of DC Electricity Meters (PE/PSIM/TEDCEM)P2960
- IEEE Program Manager
- Meng Zhao
Contact Meng Zhao - Working Group Chair
- jian yang
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards