This standard specifies a measurement method for evaluating the suppression capability of filters in the frequency range of 100 Hz to 10 GHz. The standard applies to Electromagnetic Interference (EMI) filters in general i.e., DC, single phase or poly phase systems. The measurement method describes general considerations, such as method of standardizing source impedance for nonlinear loads, temperature rise, attenuation measurement, components, and or derating requirements when supplying non-sinusoidal load currents and operating in matched or mismatched impedance environments.
- Standard Committee
- EMC/SDCom - Standards Development Committee
- Status
- Active PAR
- PAR Approval
- 2024-09-26
- Superseding
- 1560-2005
Working Group Details
- Society
- IEEE Electromagnetic Compatibility Society
- Standard Committee
- EMC/SDCom - Standards Development Committee
- Working Group
-
TC-4_WG - Radio Frequency Power Line Interference Working Group
- IEEE Program Manager
- Jennifer Santulli
Contact Jennifer Santulli - Working Group Chair
- Daria Nemashkalo
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
1560-2005
IEEE Standard for Methods of Measurement of Radio Frequency Power Line Interference Filter in the Range of 100 Hz to 10 GHz
Uniform methods of measurements of radio-frequency power-line interference filter attenuation performance in the range of 100 Hz to 10 GHz are set forth. Nonloaded and loaded attenuation measurements are presented with varying source impedance, including radiofrequency current injection with linear and nonlinear load impedances. H- and S-parameter measurements are introduced for modeling results. New methods for placing filter performance criteria on a filter label are also included.