The voltage endurance testing of form-wound bars and coils for use in large rotating machines is covered.
- Standard Committee
- DEI/SC - Standards Committee
- Status
- Inactive-Reserved Standard
- PAR Approval
- 1994-03-17
- Superseded by
- 1043-2025
- Superseding
- 1043-1989
- Board Approval
- 1996-09-19
- History
-
- ANSI Approved:
- 1997-02-06
- Published:
- 1997-11-30
- Reaffirmed:
- 2009-09-11
- Inactivated Date:
- 2021-03-25
Working Group Details
- Society
- IEEE Dielectrics and Electrical Insulation Society
- Standard Committee
- DEI/SC - Standards Committee
- Working Group
-
ADMIN_8249 - Project Administration_8249
- IEEE Program Manager
- Dalisa Gonzalez
Contact Dalisa Gonzalez
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
1043-2025
IEEE Recommended Practice for Voltage-Endurance Testing of Form-Wound Bars and Coils
A comprehensive framework for the voltage-endurance testing of form-wound bars and coils used in large rotating machine stator windings is provided in this recommended practice. The procedures for conducting voltage endurance tests on bars/coils with nominal voltage up to 30 000 V, and operating frequencies of 50 Hz or 60 Hz, are outlined. Power supply and voltage requirements, test set-up, specimen preparation, pre-test evaluation methods, as well as temperature and voltage application and measurement methods are specified. Guidelines for failure investigations, suggested test records, and test report requirements are provided.
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
1043-1989
IEEE Recommended Practice for Voltage-Endurance Testing of Form-Wound Bars and Coils
Superseded by 1043-1996. The voltage endurance testing of form-wound bars and coils for use in large rotating machines is covered.
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards