Superseded by 1043-1996. The voltage endurance testing of form-wound bars and coils for use in large rotating machines is covered.
- Standard Committee
- DEI/VE - Voltage Endurance
- Status
- Superseded Standard
- Superseded by
- 1043-1996
- Board Approval
- 1989-08-17
- History
-
- ANSI Approved:
- 1990-01-12
- Published:
- 1989-12-07
Working Group Details
- Society
- IEEE Dielectrics and Electrical Insulation Society
- Standard Committee
- DEI/VE - Voltage Endurance
- Working Group
-
VE Standard - Voltage endurance Testing of stator bars and coil_P1043
- IEEE Program Manager
- Dalisa Gonzalez
Contact Dalisa Gonzalez - Working Group Chair
- Reza Soltani
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
P1043
Recommended Practice for Voltage-Endurance Testing of Form-Wound Bars and Coils
IEEE Std. 1043™ provides a comprehensive framework for the voltage-endurance testing of form-wound bars and coils used in large rotating machine stator windings. This recommended practice outlines the procedures for conducting voltage endurance test on bars/coils with nominal voltage up to 30,000 V, and operating frequencies of 50 Hz or 60 Hz. The standard specifies power supply and voltage requirements, test set-up, specimen preparation, pre-test evaluation methods, as well as temperature and voltage application and measurement methods. The recommended practice also provides guidelines for failure investigations, suggested test records and test report requirements.
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards