Tag: communications

ISO/IEC/IEEE International Standard – Information technology – Telecommunications and information exchange between systems – Local and metropolitan area networks – Specific requirements Part 1AX–Link Aggregation

MAC-independent Link Aggregation capability and general information relevant to specific MAC types are defined in this standard. Link Aggregation allows parallel full-duplex point-to-point links to be used as if they…

ISO/IEC/IEEE International Standard – Information technology – Telecommunications and information exchange between systems – Local and metropolitan area networks – Part 1X: Port-based network access control AMENDMENT 1: MAC security key agreement protocol (MKA) extensions

Media Access Control security (MACsec) Key Agreement protocol (MKA) data elements and procedures that provide additional security and manageability capabilities, including the ability to maintain secure communication while the operation…

IRE Standards on Navigation Aids: Definitions of Inertial Navigation Terms, 1962

Definitions of Inertial Navigation Terms

IEEE Standard for High Data Rate Wireless Multi-Media Networks Amendment 2: 100 Gb/s Wireless Switched Point-to-Point Physical Layer

An alternative physical layer (PHY) at the lower THz frequency range between 252 GHz and 325 GHz for switched point-to-point links is defined in this amendment. Two PHY modes are…

IEEE Standard Definitions of Basic Per Unit Quantities for Alternating- Current Rotating Machines

Since rotating machines convert mechanical energy to electrical energy, or electrical energy to mechanical energy, base values for each kind of energy appear desirable. However, the relationships between these energies…

AIEE Standard for Aircraft Direct- Current Apparatus Voltage Ratings

Aircraft Direct-Current Apparatus Voltage Ratings

IEEE Trial-Use Standard on Video Signal Transmission Measurement of Linear Waveform Distortion

This standard describes methods for measuring the linear waveform distortions of TV video signals, that is, distortions which are caused by amplitude-independent (linear) transmission characteristics of television equipment and facilities.1…

IEEE Recommended Guide for Making Dielectric Measurements in the Field

The following general methods of test are either discussed or referred to in this publication:Low-frequency, low- and high-voltage losscharacteristic measurements. The measurement at power frequencies of power factor, dissipation factor…

IEEE Standard Test Procedure for Measuring Longitudinal Balance of Telephone Equipment Operating in the Voice Band

Telephone companies and equipment manufacturers have generally agreed on a definition for longitudinal balance for many years. This agreement extends also to the basic approach followed when measuring balance. Testing…