This document describes near-field test practices for the measurement of antenna properties. It is written for the person responsible or otherwise involved in operating the test system. It recommends procedures…
This guide discusses both on-line and off-line partial discharge (PD) measurements on complete windings of any type, as well as measurements on individual form-wound coils and bars. Measurements selected from…
This standard sets terms, test methods, test circuits, measurement procedures and preferred result values for silicon thyristor-based surge protective components used for overvoltage or overcurrent or both protection in low-voltage…
This is a guide describing the surge voltage, surge current, and temporary overvoltage (TOV) environment in low voltage [up to 1000 V root mean square (rms)] ac power circuits. This…
This recommended practice defines recommendations for surge testing performance of surge testing on electrical and electronic equipment connected to low-voltage ac power circuits, specifically using the recommended test waveforms defined…
Guidance for technical requirements for the design, fabrication, testing, and installation of indoor gas-insulated substations (GIS) 1 kV up to 52 kV is provided in this standard. Parameters to be…
An electric penetration assembly is an assembly of insulated electric conductors, conductor seals, module seals (if any), and aperture seals that provides the passage of the electric conductors through a…
It is required that Class 1E motors, with their interfaces, meet or exceed the specified performance requirements throughout their service life. This is accomplished through a program that includes, but…
This document provides quantity definitions for designing and using instrumentation for the measurement of electric power quantities under sinusoidal, nonsinusoidal, balanced, and unbalanced conditions.
