P1394 - Standard for a High-Performance Serial Bus
Project Details
This standard describes a high-speed, low-cost serial bus suitable for use as a peripheral bus, a backup to parallel backplane buses, or a local area network. Highlights of the serial bus include the following: a)Bus transactions that include both block and single quadlet reads and writes, as well as an "isochronous" mode that provides a low-overhead guaranteed bandwidth service. b)A fair bus access mechanism that guarantees all nodes equal access. The backplane environment adds a priority mechanism, but one that ensures that nodes using the fair protocol are still guaranteed at least partial access. c)Automatic assignment of node addresses--no need for address switches. d)A physical layer (PHY) supporting both long-haul and short-haul cable media and backplane buses. e)Variable speed data transmission based on ISDN-compatible1 bit rates from 24.576 Mbit/s for transistor-transistor logic (TTL) backplanes to 49.152 Mbit/s for backplane transceiver logic (BTL) backplanes. For the cable medium, data transmission rates of 98.304 Mbit/s (known as S100), S200, S400, S800, S1600, and S3200 are supported. f)A short-haul cable medium that allows up to 16 physical connections (cable hops), each up to 4.5 m, giving a total cable distance of 72 m between any two devices. Bus management recognizes smaller configurations to optimize performance. g)A long-haul cable medium that permits connections up to 100 m in length over unshielded twisted pair (UTP) cable and glass optical fiber (GOF) and up to 50 m over plastic optical fiber (POF). h)Consistency with ISO/IEC 13213:1994 (IEEE Std 1212(TM), 1994 Edition).
Sponsor Committee
Par Approval
Additional Resources Details
Historical Base Standard
Working Group Details
Working Group
Sponsor Committee
IEEE Program Manager
Existing Standards