Standard Details
The use of some electrical equipment attached to typical power systems creates power quality concerns. There is an increasing awareness that some equipment is not designed to withstand the surges, faults, distortion, and reclosing duty present on typical utility distribution systems. Traditional concerns about steady-state voltage levels and light flicker due to voltage fluctuation also remain. These concerns are addressed by this guide by documenting typical levels of these aspects of power quality and indicating how to improve them. Other documents that treat these subjects in more detail are referenced.
Standards Committee | |
Status |
Active
|
Board Approval |
2018-09-27
|
History |
Published Date:2018-11-16
|
Additional Resources Details
PAR |
Working Group Details
Working Group |
PQ-1250_WG - P1250_Voltage Quality Working Group
|
Working Group Chair |
Nicholas Zagrodnik
|
Standards Committee | |
Society | |
IEEE Program Manager | |
Existing Standards |
The use of some electrical equipment attached to typical power systems creates voltage quality concerns. There is an increasing awareness that some equipment is not designed to withstand the surges, faults, distortion, and reclosing duty present on typical utility distribution systems. Traditional concerns about steady-state voltage levels and light flicker due to voltage fluctuation also remain. These concerns are addressed by this guide by documenting typical levels of these aspects of voltage quality and indicating how to improve them. Other documents that treat these subjects in more detail are referenced.
|
Appropriate voltage sag indices and characteristics of electrical power and supply systems as well as the methods for calculating them are identified. Methods are provided for quantifying the severity of individual voltage sag events, for quantifying the performance at a specific location (single-site indices), and for quantifying the performance of the whole system (system indices). Multiple methods are presented for each. The methods are appropriate for use in transmission, distribution, and utilization electric power systems.
|