287_WG - Precision Coaxial Connectors Working Group

IM/HFM - TC4 - High Frequency Measurement

The scope of this standard is to specify coaxial connectors for precision electrical measurements for use at RF, microwave and millimeter-wave frequencies. Current state-of-the-art coaxial connectors are covered by the Standard.

This Recommended Practice specifies the mechanical and electrical test procedures that are recommended to be used for precision coaxial connectors used at RF, microwave and millimeter-wave frequencies. Current state-of-the-art test procedures are covered by this Recommended Practice.

The scope of this standard is to specify coaxial connectors for precision electrical measurements to 110 GHz. The frequency range of the standard is increased from 65 GHz to 110 GHz since in the market exists a 1 mm connector with a rated upper minimum operating frequency of 110 GHz.

This standard presents the combined efforts of IEEE Subcommittee P287 that reflect the knowledge and experience of leading specialists in the development and measurement of precision coaxial connectors from dc to 110 GHz. It presents minimum performance requirements to standardize both hermaphroditic and pin- and socket-type connectors. It provides recommended electrical and mechanical test procedures for general and laboratory precision connectors. A bibliography provides a list of pertinent references for measurement techniques used in determining electrical, mechanical, and dimensional parameters for coaxial connectors. Remarks: Revision of IEEE Std 287-1968