This standard applies to tests for high voltage fuses I above 600 volts), secondary fuses, distribution enclosed single-pole air switches, and accessories, as follows: (1) Enclosed, open, and open-link types of distribution cutouts and fuses for alternating-current distribution systems. (2) Secondary fuses, 600 volts and below, used on supply circuits. Cartridge-type fuses, rated 600 volts and below, and screw plug fuses are not included. (3) Distribution oil cutouts. (4) Distribution enclosed single-pole air switches. (5) Power fuses for systems or circuits above 600 volts. (6) Outdoor and indoor fuse disconnecting switches. (7) Fuse supports, fuse mountings, fuse hooks, fuse tongs, and fuse links, all of the type used exclusively with products listed in ( 1 ) , ( 2 ) , ( 3 ) , ( 4 ) , ( 5 ) , and ( 6 ) (8) Removable switch blades for products listed in I'D and ( 3 ) .
- Status
- Superseded Standard
- History
-
- ANSI Approved:
- 1962-07-20
- Published:
- 1961-11-30
Working Group Details
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards