This standard deals with software for the CAMAC modular instrumentation and interface system of ANSI/IEEE Std 583-1975, Modular Instrumentation and Digital Interface System (CAMAC) (also Report EUR 4100e of the Commission of the European Communities). The report on which this document is based, ERDA Report TID-26619, was prepared by the NIM Committee* of the United States Energy Research and Development Administration (now the Department of Energy) and the ESONE Committee** of European Laboratories. The corresponding ESONE document is ESONE/RTB/02. IEEE Std 726-1979 differs from the corresponding ESONE document ESONE/RTB/02 and US Energy Research and Development Administration document TID-26619 in the following respects: (1) The keyword RECEIVE is used in place of the keyword READ for process input. (2) The section on interrupt handling is not included. In particular, reference to the WHEN statement to link an event-name to an interrupt service routine has been deleted. (3) The capability of handling errors at run-time has been deleted.
- Status
- Superseded Standard
- Board Approval
- 1978-06-16
- History
-
- Published:
- 1979-09-21
Working Group Details
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards