The use of the impulse generator for calibration purposes in electromagnetic compatibility measurements is addressed. In particular, basic information relating to the use of this device is provided, and interpretation of measurements made using instruments based on it is considered. Two methods of measurement of spectrum amplitude and impulse bandwidth are described in detail. The first method uses a video pulse technique. The second uses a substitution method in which the reference is a pulse- modulated sine-wave generator whose parameters are measured. Both techniques are capable of about equal accuracy.
- Standard Committee
- EMC/SDCom - Standards Development Committee
- Status
- Inactive-Withdrawn Standard
- Board Approval
- 1974-05-30
- History
-
- Withdrawn:
- 2004-01-16
- ANSI Approved:
- 1977-12-30
- Published:
- 1975-11-07
- Reaffirmed:
- 1998-06-25
Working Group Details
- Society
- IEEE Electromagnetic Compatibility Society
- Standard Committee
- EMC/SDCom - Standards Development Committee
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards