The resonance method in general is covered in the I R E Standards on Piezoelectric Crystals, 1958 [3]. Procedures are described in the Standards on Piezoelectric Crystals, 1957 [2], and in the literature [ 6 ] - [8], The transmission method is used for determination of fm, the frequency at minimum impedance of the sample. In addition to this measurement, the present Standard also specifies the measurement of the frequency at maximum impedance fn. A simplification of the transmission network in the 1957 Standard (Fig. 4) may be used in view of the range of parameters found in the ceramics. This simplified circuit is shown in Fig. 1. The signal generator should have an output impedance lower than the minimum impedance of the test specimen.
- Status
- Inactive-Withdrawn Standard
- Board Approval
- 1960-05-12
- History
-
- Published:
- 1961-04-04
Working Group Details
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards