General requirements and methods for qualifying electric cables and splices for nuclear facilities are provided. Cable, wire, and splices within or integral to other devices (e.g., instruments, panels, motors) should be qualified using the requirements in the applicable device standard or IEEE Std 323(TM). However, this standard's requirements may be applied to the cable, wire and splices within these devices. For qualification of fiber optic cable, refer to IEEE Std 1682(TM).
- Sponsor Committee
- PE/NPEC - Nuclear Power Engineering Committee
Learn More About PE/NPEC - Nuclear Power Engineering Committee - Joint Sponsors
-
PE/IC
- Status
- Superseded Standard
- PAR Approval
- 2011-03-31
- Superseded by
- 383-2023
- Superseding
- 383-2003
- Board Approval
- 2015-09-03
- History
-
- ANSI Approved:
- 2016-09-14
- Published:
- 2015-10-05
Working Group Details
- Society
- IEEE Power and Energy Society
Learn More About IEEE Power and Energy Society - Sponsor Committee
- PE/NPEC - Nuclear Power Engineering Committee
Learn More About PE/NPEC - Nuclear Power Engineering Committee - Working Group
-
WG_2.4 - Working Group on Cables and Splices
- IEEE Program Manager
- Christian Orlando
Contact Christian Orlando - Working Group Chair
- Robert Konnik
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
383-2023
IEEE Standard for Qualifying Electric Cables and Splices for Nuclear Facilities
General requirements and methods for qualifying electric cables, and splices for nuclear facilities are provided in this standard. Cable, wire, and splices within or integral to other devices (e.g., instruments, panels, motors) should be qualified using the requirements in the applicable device standard or IEEE/IEC Std 60780-323™:2016. However, the requirements set in this standard may be applied to the cable and splices within these devices. For qualification of fiber optic cable, refer to IEEE Std 1682™.
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
383-2003
IEEE Standard for Qualifying Class 1E Electric Cables and Field Splices for Nuclear Power Generating Stations
This standard provides general requirements, direction, and methods for qualifying Class1E electric cables, field splices, factory splices, and factory rework for service in nuclear power generating stations. Categories of cables covered are those used for power, control, and instrumentation services, including signal and communication cables. Field cables, wires, and splices are within the scope of this standard. Cables, wires, and splices within or integral to other devices(e.g., instruments, panels, motors, etc.) should be qualified using the requirements in the applicable device standard or IEEE Std 323TM-1983, as appropriate. However, this standard's requirements may be applied to the wire and cable within these devices.
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards