
This document specifies the standard approach for mapping between IEEE Std 1815™ [Distributed Network Protocol (DNP3)] and IEC 61850 (Communications Networks and Systems for Power Utility Automation). Two primary use cases are addressed: a) mapping between an IEEE 1815-based master and an IEC 61850-based remote site and b) mapping between an IEC 61850-based master and an IEEE 1815-based remote site. Mapping aspects included in the standard are: conceptual architecture; general mapping requirements; the mapping of Common Data Classes, Constructed Attribute Classes and Abstract Communication Service Interface (ACSI); cyber security requirements, the architecture of a gateway used for translation and requirements for embedding mapping configuration information into IEC 61850 System Configuration Description Language (SCL) and DNP3 Device Profile. This standard addresses a selection of features, data classes, and services of the two standards. ** NOTE: Incorporates IEEE Std 1815.1-2015/Cor 1-2016, which was not published as an individual corrigendum.
- Sponsor Committee
- PE/PSCC - Power System Communications and Cybersecurity
Learn More - Status
- Active Standard
- PAR Approval
- 2013-06-14
- Corrigendum
-
1815.1-2015/Cor 1-2016
- Board Approval
- 2015-12-05
- History
-
- ANSI Approved:
- 2017-05-09
- Published:
- 2016-12-16
Working Group Details
- Society
- IEEE Power and Energy Society
Learn More - Sponsor Committee
- PE/PSCC - Power System Communications and Cybersecurity
Learn More - Working Group
-
P0_1815.1_WG - WG for IEC 61850 and 1815mapping
Learn More - IEEE Program Manager
- Erin Morales
Contact - Working Group Chair
- Ronald Farquharson
1815.1-2015/Cor 1-2016
IEEE Approved Draft Standard for Exchanging Information between Networks Implementing IEC 61850 and IEEE Std 1815(TM) (Distributed Network Protocol - DNP3) - Corrigendum 1
The editing instructions for this corrigendum are to insert a diagram as Figure 52 in the place where it is 19 currently missing from the approved but unpublished document in Clause 8.11.6.1.6 (NOTE: This corrigendum was not published as a separate document, but was incorporated in IEEE Std 1815.1-2015)