Correcting the axis labels of a figure J1 located in annex J.
- Sponsor Committee
- PE/SUB - Substations
Learn More About PE/SUB - Substations - Status
- Superseded Standard
- PAR Approval
- 2007-09-27
- Board Approval
- 2008-03-27
- History
-
- ANSI Approved:
- 2008-07-15
- Published:
- 2008-04-02
Working Group Details
- Society
- IEEE Power and Energy Society
Learn More About IEEE Power and Energy Society - Sponsor Committee
- PE/SUB - Substations
Learn More About PE/SUB - Substations - Working Group
-
WGD2 - WGD2 - Cable Systems in Substations
- IEEE Program Manager
- Patricia Roder
Contact Patricia Roder - Working Group Chair
- Prudhvi Anand Bhattiprolu
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
P525
Guide for the Design and Installation of Cable Systems in Substations
This document is a guide for the design, installation, and protection of insulated wire and cable systems in substations with the objective of minimizing cable failures and their consequences. Cable systems with voltages greater than 35kV are not covered in this guide.
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
525-2016
IEEE Guide for the Design and Installation of Cable Systems in Substations
The design, installation, and protection of wire and cable systems in substations are covered in this guide, with the objective of minimizing cable failures and their consequences
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
525-1992
IEEE Guide for the Design and Installation of Cable Systems in Substations
Guidance for the design, installation, and protection of wire and cable systems in substations with the objective of minimizing cable failures and their consequences is provided. The design of wire and cable systems in gen
525-2007
IEEE Guide for the Design and Installation of Cable Systems in Substations
The design, installation, and protection of wire and cable systems in substations with the objective of minimizing cable failures and their consequences are covered in this guide.
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards