Working Group Details
ET_WG - Electronic Transformer Working Group
|Working Group Chair||
|IEEE Program Manager|
Pulse transformers for use in electronic equipment are considered. This standard applies to the following transformer types: power output (drivers), impedance matching, interstage coupling, current sensing, and blocking-oscillator transformers. For these transformers, the peak power transmitted ranges from a few milliwatts to many kilowatts, and the peak voltage transmitted ranges from a few volts to many kilovolts. Symbols, performance tests, equivalent circuits, preferred test methods, marking, and service conditions are covered.
436-1991 - IEEE Guide for Making Corona (Partial Discharge) Measurements on Electronics Transformers
A uniform procedure for making corona (partial discharge) measurements by electrical means on electronic transformers is presented. Methods of applying voltage stress, the use of a sine-wave voltage to simulated dc and ac combinations, the types and limitations of voltage stresses encountered, and the acceptable limits of discharge pulse energy are included. Recommended test conditions and the need for negotiation of special tests are discussed. Test apparatus and calibration are described. The aim is to establish a common ground of understanding between transformer and systems design engineers and transformer manufacturers in the development of service and performance requirements.
Ferroresonant transformers used as regulators in electronic power supplies and in other equipment are covered. Guides to application and test procedures are included.