Standard Details
The editing instructions for this corrigendum are to insert a diagram as Figure 52 in the place where it is 19 currently missing from the approved but unpublished document in Clause 8.11.6.1.6
(NOTE: This corrigendum was not published as a separate document, but was incorporated in IEEE Std 1815.1-2015)
Standards Committee | |
Status |
Active
|
Board Approval |
2016-12-07
|
History |
Published Date:2016-12-16
|
Additional Resources Details
PAR |
Working Group Details
Working Group |
P0_1815.1_WG - WG for IEC 61850 and 1815mapping
|
Working Group Chair |
Ronald Farquharson
|
Standards Committee | |
Society | |
IEEE Program Manager | |
Existing Standards |
This document specifies the standard approach for mapping between IEEE Std 1815? [Distributed Network Protocol (DNP3)] and IEC 61850 (Communications Networks and Systems for Power Utility Automation). Two primary use cases are addressed: a) mapping between an IEEE 1815-based master and an IEC 61850-based remote site and b) mapping between an IEC 61850-based master and an IEEE 1815-based remote site. Mapping aspects included in the standard are: conceptual architecture; general mapping requirements; the mapping of Common Data Classes, Constructed Attribute Classes and Abstract Communication Service Interface (ACSI); cyber security requirements, the architecture of a gateway used for translation and requirements for embedding mapping configuration information into IEC 61850 System Configuration Description Language (SCL) and DNP3 Device Profile. This standard addresses a selection of features, data classes, and services of the two standards.
** NOTE: Incorporates IEEE Std 1815.1-2015/Cor 1-2016, which was not published as an individual corrigendum.
|