Use of electrical power on the seabed is increasing. Both within the oil and gas and renewable industries there is an increasing use of electrical power equipment on the seabed. Subsea processing activities like compression and pumping require an increasingly higher amount of electrical power. Power generation, whether onshore or offshore requires development of equipment both for subsea transmission and distribution. This standard includes requirements related to equipment installed below the sea surface. The objective of this standard is to substitute project/client specific specifications are used both for design and testing.
Working Group Details
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
Subsea Equipment u2013 Part 3: Subsea Motors
This standard defines the requirements for operation and design of three phase subsea liquid filled motors and subsea gas filled motors with a minimum rated power of 375 kW and with rated voltages up to and including 13.8 kV. This standard includes induction motors, permanent magnet motors and machines having an integrated load (e.g. a pump or compressor). This standard is applicable to variable speed motors and to single speed motors (also called Direct On Line motors). Considering the unique operational environment, this standard specifies additional requirements while consolidating applicable requirements from API standard 541 (for induction motors) and API standard 546 (for brushless synchronous motors), as well as IEC 60034, NEMA MG1 or IEEE 112 that are appropriate for electric motors used in a subsea environment. The scope of the document excludes motors rated for nominal system voltages 1000 volts or less and subsea electric submersible pump (ESP) motors.
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
IEEE/IEC International Standard for Subsea equipment--Part 1: Power connectors, penetrators and jumper assemblies with rated voltage from 3 kV (Umax = 3,6 kV) to 30 kV (Umax = 36 kV)
This document is applicable to single and three-phase wet-mateable and dry-mateable AC connectors, penetrators and jumper assemblies with rated voltages from 3 kV (Umax = 3,6 kV) to 30 kV (Umax = 36 kV). This document relates to the requirements and tests for products in the "as manufactured and supplied" condition. This document is not applicable to requirements and tests for products that have been subsequently installed, deployed or retrieved.
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards