This Guide provides example applications for applying harmonic limits on power systems. These applications will focus on the limits and procedures outlined in IEEE 519-2014.
- Sponsor Committee
- PE/T&D - Transmission and Distribution
Learn More - Status
- Active PAR
- PAR Approval
- 2016-03-03
Working Group Details
- Society
- IEEE Power and Energy Society
Learn More - Sponsor Committee
- PE/T&D - Transmission and Distribution
Learn More - Working Group
-
PQ-Harmonics_WG - P519_Recommended Practices and Requirements for Harmonic Control in Electric Power Systems
Learn More - IEEE Program Manager
- Michael Kipness
Contact - Working Group Chair
- David Zech
P519
IEEE Draft Standard for Harmonic Control in Electric Power Systems
Goals for the design of electrical systems that include both linear and nonlinear loads are established in this standard. The voltage and current waveforms that may exist throughout the system are described, and waveform distortion goals for the system designer are established. The interface between sources and loads is described as the point of common coupling and observance of the design goals will reduce interference between electrical equipment. This standard addresses steady-state limitations. Transient conditions exceeding these limitations may be encountered. This document sets the quality of power that is to be provided at the point of common coupling. This document does not cover the effects of radio-frequency interference; however, guidance is offered for wired telephone systems.
519-2014
IEEE Recommended Practice and Requirements for Harmonic Control in Electric Power Systems
Goals for the design of electrical systems that include both linear and nonlinear loads are established in this recommended practice. The voltage and current waveforms that may exist throughout the system are described, and waveform distortion goals for the system designer are established. The interface between sources and loads is described as the point of common coupling and observance of the design goals will reduce interference between electrical equipment. This recommended practice addresses steady-state limitations. Transient conditions exceeding these limitations may be encountered. This document sets the quality of power that is to be provided at the point of common coupling. This document does not cover the effects of radio-frequency interference; however, guidance is offered for wired telephone systems.
No Superseded Standards
No Inactive-Withdrawn Standards
No Inactive-Reserved Standards