Inactive-Withdrawn Standard

IEEE 605-1987

IEEE Guide for Design of Substation Rigid-Bus Structures

Rigid-bus structures for outdoor and indoor, air-insulated, and alternating-current substations are covered. Portions of this guide are also applicable to strain-bus structures or direct-current substations, or both. Ampacity, radio influence, vibration, and forces due to gravity, wind, fault current, and thermal expansion are considered. Design criteria for conductor and insulator strength calculations are included.

Sponsor Committee
PE/SUB - Substations
Learn More About PE/SUB - Substations
Status
Inactive-Withdrawn Standard
Superseded by
605-1998
Board Approval
1984-06-14
History
Withdrawn:
1993-12-02
ANSI Approved:
1985-11-15
Published:
1987-05-20

Working Group Details

Society
IEEE Power and Energy Society
Learn More About IEEE Power and Energy Society
Sponsor Committee
PE/SUB - Substations
Learn More About PE/SUB - Substations

Other Activities From This Working Group

Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.


No Active Projects

Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.


No Active Standards

These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.


No Superseded Standards

These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.


No Inactive-Withdrawn Standards

These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.


No Inactive-Reserved Standards
Subscribe to our Newsletter

Sign up for our monthly newsletter to learn about new developments, including resources, insights and more.