Superseded Standard

IEEE 390-1975

IEEE Standard for Low Power Pulse Transformers

This standard pertains t o small low-power pulse transformers for use in electronic equipment, transmitting peak power of 300 W or less and average power of 5W or less with a peak working voltage of 1000 V or less. These transformers are required to transform unipolar or bipolar pulses of voltage or current within specified tolerances of amplitude and time when operated between specified impedance. This standard is not intended to include low-power switching type pulse transformers which are covered in IEEE Std 272-1970, Standard for Computer-Type (Square-Loop) Pulse Transformers. These transformers depend upon the use of square - loop core material for operation, have memory capability, and normally transmit only bipolar pulses unless provision is made for core flux reset. This standard is not intended to include transformers for power conversion applications. T h o s e transformers will be covered in a related standard. Whenever numerical values are indicated they may be considered as recommended values. Section 2 contains definitions of terms pertaining primarily to functional testing of low-power pulse transformers, and Section 5 contains equivalent circuits a n d definitions of associated terms. Section 6 describes preferred transformer test methods and the appendix contains alternate test methods.

Status
Superseded Standard
Board Approval
1973-12-13
History
Published:
1975-06-18

Working Group Details

Other Activities From This Working Group

Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.


No Active Projects

Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.


No Active Standards

These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.


No Superseded Standards

These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.


No Inactive-Withdrawn Standards

These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.


No Inactive-Reserved Standards
Subscribe to our Newsletter

Sign up for our monthly newsletter to learn about new developments, including resources, insights and more.