IEEE-SA
Standards Board Actions - September 27, 2007
APPROVED
PARS FOR NEW STANDARDS
P525-2007/Cor 1 (PE/SUB)
Guide for the Design and Installation of Cable Systems in Substations - Corrigendum 1
P802.1ak-2007/Cor 1 (C/LM)
IEEE Standard for Local and Metropolitan Area Networks – Virtual Bridged Local Area Networks - Amendment
07: Multiple Registration Protocol - Corrigendum 1: Corrections to the Multiple Registration Protocol
P802.3az (C/LM)
IEEE Standard for Information Technology - Telecommunications and Information Exchange Between Systems - Local and Metropolitan Area Networks - Specific Requirements Part 3: Carrier Sense Multiple Access with Collision Detection (CSMA/CD) Access Method and Physical Layer Specifications - Amendment: Media Access Control Parameters, Physical Layers and Management Parameters for Energy-Efficient Ethernet
P1127a (PE/SUB)
IEEE Guide for the Design, Construction, and Operation of Electric Power Substations for Community Acceptance
and Environmental Compatibility - Amendment: IEEE Guide for the Design, Construction, and Operation of
Electric Power Substations for Community Acceptance and Environmental Compatibility - Amendment to remove
references to Substation Slide Library
P1727 (PE/IC)
Guideline For Working Procedures On Underground Transmission Circuits With Induced Voltage
P1729 (PE/PSACE)
Recommended Practice for Electric Power Distribution System Analysis
P15939 (C/S2ESC)
Standard for Systems and software engineering — Measurement process
P11073-10441 (EMB/11073)
Standard for Health informatics - Personal health device communication - Device specialization – Cardiovascular
fitness and activity monitor
P11073-10442 (EMB/11073)
Standard for Health informatics - Personal health device communication - Device specialization – Strength fitness
equipment
P11073-10471 (EMB/11073)
Standard for Health informatics - Personal health device communication - Device specialization – Independent
living activity hub
P11073-10472 (EMB/11073)
Standard for Health informatics - Personal health device communication - Device specialization – Medication
Monitor
PC37.301 (PE/SWG)
Standard for High-Voltage (Above 1000 V) Test Techniques - Partial Discharge Measurements
MODIFIED
PARS
1028 (C/S2ESC)
Standard for Software Reviews and Audits
P1407 (PE/IC)
Guide for Accelerated Aging Tests for Medium-Voltage (5 kV-35 kV) Extruded Electric Power Cables Using
Water-Filled Tanks
P1542 (PE/T&D)
Guide for Installation, Maintenance and Operation of Irrigation Equipment Located Near or Under Power Lines
P1625(PE/SB)
Standard for Rechargeable Batteries for Multi-cell Mobile Computing Devices
P1657 (PE/SB)
Recommended Practice for Personnel Qualifications for Installation, Maintenance, and Operation of Stationary
Batteries
P1686 (PE/SUB)
Standard for Substation Intelligent Electronic Devices (IED) Cyber Security Capabilities
P1900.1 (COM/SC)
Standard Definitions and Concepts for Dynamic Spectrum Access: Terminology Relating to Emerging Networks,System Functionality, and Spectrum Management
P11073-30400 (EMB/11073)
Standard for Health informatics - Point-of-care medical device communication - Interface profile - Cabled Ethernet
P12207 (C/S2ESC)
Standard for Systems and Software Engineering — Software Life Cycle Processes
P15288 (C/S2ESC)
Standard for Systems and Software Engineering — System life cycle processes
PC37.1 (PE/SUB)
Standard for SCADA and Automation Systems
PC37.2 (PE/SUB)
Standard Electrical Power System Device Function Numbers, Acronyms and Contact Designations
PC37.13 (PE/SWG)
Standard for Low-Voltage AC Power Circuit Breakers Used in Enclosures
PC37.27 (PE/SWG)
Application Guide for Low-Voltage AC Power Circuit Breakers Applied With Separately Mounted Current-Limiting Fuses
PARS
FOR REVISIONS OF STANDARDS
P367(PE/PSC)
Recommended Practice for Determining the Electric Power Station Ground Potential Rise and Induced Voltage
from a Power Fault
P515.1 (IAS/PCI)
Standard for the Testing, Design, Installation, and Maintenance of Electrical Resistance Heat Tracing for
Commercial Applications
P1730 (C/SISO)
Recommended Practice for Distributed Simulation Engineering and Execution Process (DSEEP)
P24765 (C/S2ESC)
Systems and software engineering -- Vocabulary
P42010 (C/S2ESC)
Standard for Systems and Software Engineering --- Architectural Description
WITHDRAWN
PARS
P802.16-2004/Cor 2 (C/LM)
Standard for Local and metropolitan area networks - Part 16: Air Interface for Fixed and Mobile Broadband
Wireless Access Systems Corrigendum 2
P1175.5 (C/S2ESC)
IEEE Standard for CASE Tool Interconnections - Syntax for Transferring Behavior Specifications
P1643 (EMC/SDCom)
Recommended Practice for Protecting Voting Equipment and Systems from Intentional EMI
P1402 (PE/SUB)
Guide for Electric Power Substation Physical and Electronic Security
PC37.301 (PE/SWG)
Recommended Practice for Partial Discharge Measurement in Power Switchgear Rated above 1000 V
NEW STANDARDS
P802.1ag (C/LM)
Standard for Local and Metropolitan Area Networks - Virtual Bridged Local Area Networks - Amendment 5: Connectivity Fault Management
P802.16g (C/LM & MTT)
Standard for Local and Metropolitan Area Networks − Part 16: Air Interface for Fixed and Mobile Broadband Wireless Access Systems − Amendment 3: Management Plane Procedures and Services
P1484.20.1 (C/LT)
Standard for Learning Technology – Data Model for Reusable Competency Definitions
P1516.4 (C/SI)
Recommended Practice for Verification, Validation, and Accreditation of a Federation — an Overlay to the High Level Architecture Federation Development and Execution Process
P1542 (PE/T&D)
Guide for Installation, Maintenance, and Operation of Irrigation Equipment Located Near or Under Power Lines
P1617 (PE/IC)
Guide for Detection, Mitigation, and Control of Concentric Neutral Corrosion in Medium Voltage Underground Cables
P1636.1 (SCC20)
Trial-Use Standard for Software Interface for Maintenance Information Collection and Analysis (SIMICA): Exchanging Test Results and Session Information Via the eXtensible Markup Language (XML)
P1661 (SCC21)
Guide for Test and Evaluation of Lead-Acid Batteries Used in Photovoltaic (PV) Hybrid Power Systems
PC37.230 (PE/PSR)
Guide for Protective Relay Applications to Distribution Lines
PC37.235 (PE/PSR)
Guide for the Application of Rogowski Coils Used for Protective Relaying Purposes
PC57.12.36 (PE/TR)
Standard Requirements for Liquid-Immersed Distribution Substation Transformers
REVISED STANDARDS
P99 (SCC04)
Recommended Practice for the Preparation of Test Procedures for the Thermal Evaluation of Insulation Systems for Electrical Equipment
P495 (PE/IC)
Guide for Testing Faulted Circuit Indicators
P532 (PE/IC)
Guide for Selecting and Testing Jackets for Power, Instrumentation, and Control Cables
P741 (PE/NPE)
Standard Criteria for the Protection of Class 1E Power Systems and Equipment in Nuclear Power Generating Stations
P1189 (PE/SB)
Guide for Selection of Valve-Regulated Lead-Acid (VRLA) Batteries for Stationary Applications
PC37.20.7 (PE/SWG)
Guide for Testing Metal-Enclosed Switchgear Rated Up to 38kV for Internal Arcing Faults
PC57.12.35 (PE/TR)
Standard for Bar Coding for Distribution Transformers and Step-Voltage Regulators
PC57.129 (PE/TR)
Standard for General Requirements and Test Code for Oil-Immersed HVDC Converter Transformers
REAFFIRMATIONS
95-2002 (PE/EM)
IEEE Recommended Practice for Insulation Testing of AC Electric Machinery (2300 V and Above) With High Direct Voltage
98-2002 (SCC04)
IEEE Standard for the Preparation of Test Procedures for the Thermal Evaluation of Solid Electrical Insulating Materials
111-2000 (PEL)
IEEE Standard for Wide-Band (Greater Than 1 Decade) Transformers
252-1995 (R2002) (PE/EM)
IEEE Standard Test Procedure for Polyphase Induction Motors Having Liquid in the Magnetic Gap
387-1995 (R2001) (PE/NPE)
IEEE Standard Criteria for Diesel-Generator Units Applied as Standby Power Supplies for Nuclear Power Generating Stations
388-1992 (R1998) (PEL)
IEEE Standard for Transformers and Inductors in Electronic Power Conversion Equipment
389-1996 (PEL)
IEEE Recommended Practice for Testing Electronics Transformers and Inductors
390-1987 (R1998) (PEL)
IEEE Standard for Pulse Transformers
393-1991 (R1998) (PEL/ET)
IEEE Standard for Test Procedures for Magnetic Cores
449-1998 (PEL)
IEEE Standard for Ferroresonant Voltage Regulators
563-1978 (R2002) (PE/T&D)
IEEE Guide on Conductor Self-Damping Measurements
637-1985 (R2002) (PE/TR)
IEEE Guide for the Reclamation of Insulating Oil and Criteria for Its Use
664-1993 (R2000) (PE/T&D)
IEEE Guide for Laboratory Measurement of the Power Dissipation Characteristics of Aeolian Vibration Dampers for Single Conductors
691-2001 (PE/T&D)
IEEE Guide for Transmission Structure Foundation Design and Testing
1063-2001 (C/S2ESC)
IEEE Standard for Software User Documentation
1110-2002 (PE/EM)
IEEE Guide for Synchronous Generator Modeling Practices and Applications in Power System Stability Analyses
1122-1998 (PE/PSIM)
IEEE Standard for Digital Recorders for Measurements in High-Voltage Impulse Tests
1175.1-2002 (C/S2ESC)
IEEE Guide for CASE Tool Interconnections - Classification and Description
1425-2001 (PE/IC)
IEEE Guide for the Evaluation of the Remaining Life of Impregnated Paper-Insulated Transmission Cable Systems
1802.3-2001 (C/LM)
IEEE Conformance Test Methodology for IEEE Standards for Local and Metropolitan Area Networks - Specific Requirements - Part 3: Carrier Sense Multiple Access with Collision Detection (CSMA/CD) Access Method and Physical Layer Specifications
C37.09-1999 (PE/SWG)
IEEE Standard Test Procedure for AC High-Voltage Circuit Breakers Rated on a Symmetrical Current Basis
[Also C37.09a-2005 and C37.09-1999/Cor1-2007]
C37.20.1-2002 (PE/SWG)
IEEE Standard for Metal-Enclosed Low-Voltage Power Circuit Breaker Switchgear
[Also C37.20.1a-2005 and C37.20.1b-2006]
