Inactive-Withdrawn Standard

IEEE 753-1983

IEEE Standard Functional Methods and Equipment for Measuring the Performance of Dial-Pulse (DP) Address Signaling Systems

The scope of this standard is two-fold. First, to establish and define requirements for methods which can be used to measure the performance of dial-pulse address signaling systems used with voice frequency telecommunications equipment. Second, to establish functional requirements for test equipment needed to make the measurements. Such standard conditions as will be possible with these methods and means are mandatory if consistent and repeatable test results are to be obtained. This standard will be limited to the parameters of dial-pulse signaling systems used in the North-American network that affect addressing performance. These parameters shall be measured at appropriate access points within the telecommunications switching system, on associated local subscriber loops, on trunks interconnecting switching systems, or on station apparatus. Measurements of supervisory signals or of the time relationship between supervisory and dial-pulse address signals, are not included. Signaling systems other than dial pulse (for example, single frequency in-band or out of band) which results in a dial-pulse address may require testing using methods and equipment covered by this standard.

Sponsor Committee
COM/TRANS - Transmission Systems
Status
Inactive-Withdrawn Standard
Board Approval
1983-03-17
History
Withdrawn:
1991-12-05
ANSI Approved:
1984-02-01
Published:
1983-06-23

Working Group Details

Society
IEEE Communications Society
Learn More About IEEE Communications Society
Sponsor Committee
COM/TRANS - Transmission Systems

Other Activities From This Working Group

Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.


No Active Projects

Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.


No Active Standards

These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.


No Superseded Standards

These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.


No Inactive-Withdrawn Standards

These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.


No Inactive-Reserved Standards
Subscribe to our Newsletter

Sign up for our monthly newsletter to learn about new developments, including resources, insights and more.