This is a standard for developing data related to the seismic capabilities of relays. This standard compliments ANSI/IEEE Std 344-1975, Recommended Practices for Seismic Qualification of Class IE Equipment for Nuclear Power Generating Stations, which provides general guidelines for developing data related to seismic qualification of equipment used in nuclear generating plants. Data must be developed by testing rather than analytical means since protective relays fall into the category of complex devices as described in Section 5 of ANSI/IEEE Std 344-1975; however, analysis may be used in data reduction, in reconciling response spectra, in justifying methods of evaluating changes, and in justifying seismic qualifications of relays of similar construction. While aging is recognized as a potential influence on the seismic capability of relays, insufficient definition presently exists to permit realistic simulation of end-of-life for various relays. When applicable definition of the various degrading factors and methods of accelerating the effect of these factors is developed in other related standards, they should be considered in the previbration preparation. It should be emphasized that while a primary purpose in preparing this standard was to cover the application of relays to nuclear generating plants, the standard is not restricted to this application. This standard may be applied to any area in which the seismic response of relays is a design consideration.
- Status
- Superseded Standard
- Board Approval
- 1977-12-15
- History
-
- Published:
- 1978-04-28
Working Group Details
Other Activities From This Working Group
Current projects that have been authorized by the IEEE SA Standards Board to develop a standard.
No Active Projects
Standards approved by the IEEE SA Standards Board that are within the 10-year lifecycle.
No Active Standards
These standards have been replaced with a revised version of the standard, or by a compilation of the original active standard and all its existing amendments, corrigenda, and errata.
No Superseded Standards
These standards have been removed from active status through a ballot where the standard is made inactive as a consensus decision of a balloting group.
No Inactive-Withdrawn Standards
These standards are removed from active status through an administrative process for standards that have not undergone a revision process within 10 years.
No Inactive-Reserved Standards