IEEE-SA Standards Board Approvals

New and revised standards projects, as well as new and revised standards put forth for approval by the Standards Board.

IEEE-SA STANDARDS BOARD APPROVALS
5 December 2015

New PARs

  • P802.3ca (C/LM) Approved Draft Standard for Ethernet Amendment: Physical Layer Specifications and Management Parameters for 25 Gb/s, 50 Gb/s, and 100 Gb/s Passive Optical Networks
  • P802.3cb (C/LM) Approved Draft Standard for Ethernet Amendment: Physical Layer Specifications and Management Parameters for 2.5 Gb/s and 5 Gb/s Operation over Backplane and Copper Cables
  • P802.15.4t (C/LM) Standard for Local and metropolitan area networks--Part 15.4: Low-Rate Wireless Personal Area Networks (LR-WPANs) Amendment for a Higher Rate (2 Mb/s) Physical (PHY) Layer
  • P802.15.4u (C/LM) Standard for Local and Metropolitan Area Networks -Part 15.4: Low-Rate Wireless Personal Area Networks (LR-WPANs) Amendment for Use of the 865-867 MHz Band in India
  • P802d (C/LM) Standard for Local and Metropolitan Area Networks: Overview and Architecture Amendment: Uniform Resource Names (URN) Namespace
  • P1857.8 (C/SAB) Standard for 2nd Generation Audio Coding
  • P1857.9 (C/SAB) Standard for Immersive Visual Content Coding
  • P1915.1 (COM/SDB) Standard for Software Defined Networking and Network Function Virtualization Security
  • P1916.1 (COM/SDB) Standard for Software Defined Networking and Network Function Virtualization Performance
  • P1917.1 (COM/SDB) Standard for Software Defined Networking and Network Function Virtualization Reliability
  • P11073-10101b (EMB/11073) Health informatics -- Point-of-care medical device communication -- Part 10101: Nomenclature Amendment 2: Additional definitions
  • P11073-10103a (EMB/11073) Health informatics--Point-of-care medical device communication Part 10103: Nomenclature--Implantable device, cardiac Amendment 1: Additional definitions
  • P62582-6 (PE/NPE) Nuclear power plants -- Instrumentation and control important to safety -- Electrical equipment condition monitoring methods. Part 6: Insulation resistance
  • PC37.100.5 (PE/SWG) Common Definitions for Switchgear

PARs for the Revision of Standards

  • P149 (APS/A) Recommended Practice for Antenna Measurements
  • P1502 (APS/A) Recommended Practice for Radar Cross-Section Test Procedures
  • P211 (APS/P) Standard Definitions of Terms for Radio Wave Propagation
  • P1722.1 (C/MSC) Standard for Device Discovery, Connection Management, and Control Protocol for Time-Sensitive Networking Systems
  • P1597.1 (EMC/SDC) Standard for Validation of Computational Electromagnetics Computer Modeling and Simulations
  • P515 (IAS/PCI) Standard for the Testing, Design, Installation, and Maintenance of Electrical Resistance Trace Heating for Industrial Applications
  • P115 (PE/EM) Guide for Test Procedures for Synchronous Machines Part I--Acceptance and Performance Testing Part II--Test Procedures and Parameter Determination for Dynamic Analysis
  • P1617 (PE/IC) Guide for Assessment, Mitigation, and Control of Corrosion of Metallic Shields in Extruded Dielectric Cables rated 5 kV to 46 kV
  • PC37.108 (PE/PSR) Guide for the Protection of Secondary Network Systems
  • PC37.233 (PE/PSR) Guide for Power System Protection Testing
  • PC37.24 (PE/SWG) Guide for Evaluating the Effect of Solar Radiation on Outdoor Metal-Enclosed Switchgear
  • P1505.1 (SASB/SCC20) Standard for the Common Test Interface Pin Map Configuration for High-Density, Single-Tier Electronics Test Requirements Utilizing IEEE Std 1505
  • P1636 (SASB/SCC20) Standard for Software Interface for Maintenance Information Collection and Analysis (SIMICA)

Modified PARs

  • P1834 (BOG/CAG) Technology Supervision Code for Wind Turbine Rotor Systems
  • P802.15.3d (C/LM) Standard for Information technology-- Local and metropolitan area networks-- Specific requirements-- Part 15.3: Wireless Medium Access Control (MAC) and Physical Layer (PHY) Specifications for High Rate Wireless Personal Area Networks (WPAN) Amendment for a 100 Gb/s wireless switched point-to-point physical layer
  • P1912 (COM/SDB) Standard for Privacy and Security Architecture for Consumer Wireless Devices
  • PC37.238 (PE/PSR) Standard Profile for Use of IEEE 1588 Precision Time Protocol in Power System Applications

Administratively Withdrawn PARs

  • P1619 (C/IA) Standard for Cryptographic Protection of Data on Block-Oriented Storage Devices
  • P25010 (C/S2ESC) Standard -- Adoption of ISO/IEC 25010-2010 Systems and Software Engineering -- Systems and Software Quality Requirements and Evaluation (SQuaRE) -- System and Software Quality Models
  • P1822 (EMB/Stds Com) Standard for Digital Microscope Analyzer, Whole Slide Image Scanner and Digital Microscope
  • P1580.1 (IAS/PCI) Recommended Practice for Insulated Bus Pipe for Use on Shipboard and Fixed or Floating Platforms
  • P1595 (PE/ED&PG) Standard for Designating and Quantifying Green Energy Projects in the Electricity Sector
  • P1254 (PE/IC) Guide for Soil Thermal Stability
  • P692a (PE/NPE) Standard Criteria for Security Systems for Nuclear Power Generating Stations Amendment a: Alignment with Recent Industry Security Approach Changes
  • PC93.3 (PE/PSC) Standard for the Requirements for Power-Line Carrier Line Traps (30-500 kHz)
  • P1562 (SASB/SCC21) Guide for Array and Battery Sizing in Stand-Alone Photovoltaic (PV) Systems
  • P2030.1 (SASB/SCC40) Guide for Electric-Sourced Transportation Infrastructure
  • P1833 (VT/RTSC) Guide for the Design of Direct Current Overhead Contact Systems for Transit Systems

New Standards

  • P802.1AS-2011/Cor 2 (C/LM) IEEE Draft Standard for Local and Metropolitan Area Networks - Timing and Synchronization for Time-Sensitive Applications in Bridged Local Area Networks - Corrigendum 2: Technical and Editorial Corrections
  • P802.1Q-2014/Cor 1 (C/LM) IEEE Draft Standard for Local and Metropolitan Area Networks - Bridges and Bridged Networks- Corrigendum 1: Technical and Editorial Corrections
  • P802.1Qbv (C/LM) IEEE Draft Standard for Local and Metropolitan Area Networks - Media Access Control (MAC) Bridges and Virtual Bridged Local Area Networks Amendment: Enhancements for Scheduled Traffic
  • P1857.5 (C/SAB) IEEE Draft Standard for Advanced Mobile Speech and Audio
  • P1900.6-2011/Cor 1 (COM/DySPAN-SC) IEEE Draft Standard for Spectrum Sensing Interfaces and Data Structures for Dynamic Spectrum Access and Other Advanced Radio Communication Systems. - Corrigendum 1
  • P1900.7 (COM/DySPAN-SC) IEEE Draft Radio Interface for White Space Dynamic Spectrum Access Radio Systems Supporting Fixed and Mobile Operation
  • P1906.1 (COM/SDB) IEEE Draft Recommended Practice for Nanoscale and Molecular Communication Framework
  • P11073-10101a (EMB/11073) IEEE Draft Standard Health Informatics - Point-of-Care Medical Device Communication - Nomenclature Amendment 1: Additional Definitions
  • P1673 (IAS/PCI) IEEE Draft Standard for Requirements for Conduit and Cable Seals for Field Connected Wiring to Equipment in Petroleum and Chemical Industry Exposed to Pressures above Atmospheric (1.5 kilopascals, 0.22 psi)
  • P1844 (PE/IC) IEEE Draft Standard Test Procedure for Determining Circuit Integrity Performance of Fire Resistive Cables Systems in Nuclear Facilities
  • P1815.1 (PE/SUB) IEEE Draft Standard for Exchanging Information Between Networks Implementing IEC 61850 and IEEE Std 1815 (Distributed Network Protocol - DNP3)
  • PC37.302 (PE/SWG) IEEE Draft Guide for Fault Current Limiter (FCL) Testing FCLs Rated above 1000 V AC

Revision Standards

  • P1801 (C/DA) IEEE Draft Standard for Design and Verification of Low Power, Energy Aware Electronic Systems
  • P802.15.4 (C/LM) Standard for Low-Rate Wireless Personal Area Networks (WPANs)
  • P1062 (C/S2ESC) IEEE Draft Recommended Practice for Software Acquisition
  • P1149.6 (C/TT) IEEE Draft Standard for Boundary-Scan Testing of Advanced Digital Networks
  • P1068 (IAS/PCI) IEEE Draft Standard for the Repair and Rewinding of AC Electric Motors in the Petroleum, Chemical, and Process Industries
  • P117 (PE/EM) IEEE Draft Standard Test Procedure for Thermal Evaluation of Systems of Insulating Materials for Random-Wound AC Electric Machinery
  • PC37.113 (PE/PSR) IEEE Draft Guide for Protective Relay Applications to Transmission Lines
  • PC37.13 (PE/SWG) IEEE Draft Standard for Low-Voltage AC Power Circuit Breakers Used in Enclosures
  • PC37.23 (PE/SWG) IEEE Draft Standard for Metal-Enclosed Bus
  • PC37.27 (PE/SWG) Application Guide for Low-Voltage AC (635 V and Below) Power Circuit Breakers Applied with Separately-Mounted Current-Limiting Fuses
  • PC57.12.00 (PE/TR) IEEE Draft Standard for General Requirements for Liquid-Immersed Distribution, Power, and Regulating Transformers
  • PC57.12.90 (PE/TR) Standard Test Code for Liquid-Immersed Distribution, Power, and Regulating Transformers
  • PC57.32 (PE/TR) IEEE Draft Standard Requirements, Terminology, and Test Procedures for Neutral Grounding Devices
  • PC57.94 (PE/TR) IEEE Draft Recommended Practice for Installation, Application, Operation, and Maintenance of Dry-Type Distribution and Power Transformers
  • PC57.106 (PE/TR) IEEE Draft Guide for Acceptance and Maintenance of Insulating Mineral Oil in Electrical Equipment
  • PC57.139 (PE/TR) IEEE Draft Guide for Dissolved Gas Analysis in Transformer Load Tap Changers

Revised Industry Connections Activity Approval